Ceiling Fan Installation in Seattle, Bellevue & Redmond
Mounted on a fan-rated box, balanced, and wobble-free.
A ceiling fan puts moving weight on your ceiling, which is why it needs a fan-rated box rather than the standard light box most fixtures hang from. We check what's up there first, install to a proper brace, balance the blades, and set up the remote or wall control before we leave.
We also cover the wider Puget Sound area — Kirkland, Mercer Island,
Issaquah, Sammamish, Newcastle, Renton, Lynnwood, Everett, Kent, Auburn and Tacoma.
See all service areas
What's Included
What We Handle
New fan installation and old fan replacement
Fan-rated box and brace installation where the existing box isn't rated
Blade balancing to eliminate wobble and ticking
Remote controls and wall switches configured
Downrod sizing for vaulted and high ceilings
Outdoor-rated fans for covered patios and porches
Why A-Repairs
Why Choose A-Repairs for Ceiling Fan Installation
We check the box first
A standard light box isn't built to carry a moving fan. We verify what's in your ceiling before starting and install a fan-rated brace if it's needed.
No wobble
Wobble comes from unbalanced blades or a loose mount. We balance the blade set and confirm the mount is tight, then run it on high to prove it's steady.
Controls actually set up
Remotes paired, wall controls wired, reverse switch explained for winter. You get a fan that works, not a fan plus a box of accessories.
Our Work
Ceiling Fan Installation Projects
Recent work from Seattle and the Eastside out across the wider Puget Sound area.
Modern ceiling fan installed in a bedroomFan-rated brace fitted before mountingVaulted ceiling install with extended downrod
Before & After
The Difference
BeforeDated fixture on a non-rated ceiling boxAfterNew fan on a rated brace, balanced and steady
Service Areas
Serving Seattle, Bellevue & Redmond
Based in the Seattle–Bellevue–Redmond corridor, working throughout the Puget Sound region from Everett to Tacoma.
We cover the whole corridor from Everett down to Tacoma. Seattle, Bellevue and Redmond are
our home turf, but everywhere listed above gets the same service.
Not sure if we reach your neighborhood? Just give us a call.
FAQ
Common Questions
Only if the box is fan-rated, or we install a brace that is. A standard light box can't safely hold a fan's weight and motion — we'll check and tell you what's needed.
Almost always unbalanced blades or a loose mounting bracket. Both are fixable. We balance the set and secure the mount so it runs steady.
For a straight swap on existing wiring, no. If you need a new circuit, a new switch location, or the wiring is unsafe, yes — and we'll tell you plainly.
Yes. Sloped ceilings need an angled mount and the right downrod length. Let us know the ceiling height and pitch when you call.
Yes, provided the fan is rated for damp or wet locations. We'll confirm the rating before installing.
A-Repairs
